This diagnostic trouble code, RPT 523908.19, is generated when the OIC (Operator Interface Control) control software cannot determine the values of the remote control switch for the rear PTO and cannot provide the CAN bus with any data. A transmitted…

READ MORE

This operator information (diagnostic trouble code), RPT 523908.14, is generated when the remote control switch for the rear PTO is turned on.

READ MORE

This diagnostic trouble code, RPT 523908.09, is generated when the CAN bus message from the OIC (Operator Interface Control) control software about the rear PTO remote control switch value is not updated regularly via the CAN bus. The OIC diagnostic…

READ MORE

This diagnostic trouble code, RPT 523815.19, is generated when the output for switching the solenoid for PTO speed 3 is energized by more than one control software. This indicates a conflict in control software communication.

READ MORE

This diagnostic trouble code, RPT 523815.12, is generated when the PAP control software measures a current of more than 1 A at the output to the solenoid for PTO speed 3 when the solenoid is turned off. This indicates a…

READ MORE

This diagnostic trouble code, RPT 523815.11, is generated when there is a circuit fault in the solenoid for PTO speed 3. This could be due to a shorted circuit, open circuit, or overheating of the solenoid.

READ MORE

This diagnostic trouble code, RPT 523815.09, is generated when there is a data transfer problem between the PAP (Power Accessory Point) control software and the RPT control software. The issue arises when the RPT control software intermittently or completely fails…

READ MORE

This diagnostic trouble code, RPT 523815.05, is generated when the PAP control software measures a current of less than 500 mA at the output to the solenoid for PTO speed 3 when the solenoid is turned on. This indicates that…

READ MORE

This diagnostic trouble code, RPT 523815.04, is generated when the PAP control software measures a current above 30 A when the solenoid for PTO speed 3 is turned on. This indicates a grounded circuit.

READ MORE

This diagnostic trouble code, RPT 523815.03, is generated when the PAP (Power Accessory Point) control software detects a voltage that is too high (12 volts) at the output to the solenoid for PTO speed 3 when the solenoid is turned…

READ MORE

This diagnostic trouble code, RPT 523815.01, is generated when the PAP control software measures a supply voltage of less than 3 V at the output to the solenoid for PTO speed 3 when the solenoid is turned on. This indicates…

READ MORE