Description:

This error code indicates that the Rear Hitch Draft Sensor voltage is below 0.20 volts. This could be caused by a defective sensor, poor wiring, or an issue within the control unit.

Reaction:

The HCC function is degraded when this error code is active.

Recommendations:

• Check Wiring and Connections:
  • Inspect the wiring and connectors associated with the Rear Hitch Draft Sensor for any damage, loose connections, or corrosion.
• Test the Sensor:
  • Measure the sensor’s output voltage to ensure it is within the specified range.
• Replace Faulty Components:
  • Replace the sensor or any faulty wiring if necessary.
• Calibrate the Sensor:
  • Perform a proper calibration of the Rear Hitch Draft Sensor according to the manufacturer’s instructions.
• Consult Technical Support:
  • If the problem continues, contact technical support for further diagnostics and troubleshooting.

Note:

Regular inspections and calibrations are essential to maintaining the proper operation of the Rear Hitch Draft Sensor and preventing low voltage issues.