Description:

This error code indicates that the option pin configuration for optional hitch features has changed from one supported feature to another without going through an all-disconnected configuration, which is not allowed.

Reaction:

The HCC function is disabled (OFF) when this error code is active.

Recommendations:

• Inspect Option Pin Configuration:
  • Check the current option pin configuration and compare it to the previous setup to identify any unsupported changes.
• Revert to All-Disconnected Configuration:
  • Set the option pins to an all-disconnected configuration before changing to a new supported feature.
• Correct Configuration Setup:
  • Reconfigure the option pins to the desired supported feature after ensuring the all-disconnected state.
• Restart System:
  • Restart the system after correcting the configuration to verify if the error is resolved.
• Consult Technical Support:
  • If the problem persists, contact technical support for further assistance and troubleshooting.

Note:

Following proper procedures for changing option pin configurations is crucial to avoid errors and ensure the correct operation of the hydraulic control system.