Description:

This diagnostic trouble code is generated if the PL3 control software detects an incorrect end-of-line (EOL) parameter while booting after ignition ON. The parameters are replaced by default values, which may not be optimal for vehicle operation.

Reaction:

When this code is detected, the control software will replace the incorrect EOL parameters with default values, potentially affecting vehicle performance and functionality.

Recommendations:

Inspect EOL Parameters:

• Check the control module for correct EOL parameters. Reprogram with the correct parameters if necessary.

Update Control Software:

• Ensure that the control software is up-to-date and that all patches or updates have been applied to prevent internal faults.

Check for Software Corruption:

• Verify the integrity of the control software. Reprogram or replace the control module if software corruption is detected.

Consult Technical Support:

• If the problem persists, consult technical support for further assistance in identifying and resolving the internal fault.

Note:

Internal software faults can significantly impact vehicle performance. Ensure that all control modules are properly programmed and up-to-date to maintain optimal functionality.