Description:

This diagnostic trouble code is activated when an internal electronic malfunction is detected in the control unit, similar to PLC 629.12. This could be due to issues with internal circuits, memory, or the processor of the control unit.

Reaction:

The equipment may enter a safe mode to avoid further damage, with some functions controlled by the affected unit being limited or disabled until the issue is resolved.

Recommendations:

• Inspect Control Unit:
  • Look for visible signs of damage or loose connections. Ensure all connectors are properly seated.
• Reset the Control Unit:
  • Perform a power cycle by turning off the machine, waiting for a few minutes, and then restarting it to see if the error clears.
• Update Firmware:
  • Check for and install any available firmware updates for the control unit.
• Replace Control Unit:
  • If the fault persists, consider replacing the control unit to resolve the issue.

Note:

Regular maintenance and keeping firmware up-to-date are essential to avoid internal faults in control units. Always use genuine parts for replacements to ensure compatibility and reliability.