Description:

This fault code indicates that the hand throttle sensor input is above the normal operating range, but it is at a least severe level. This might be due to a sensor issue, wiring problems, or minor calibration discrepancies.

Reaction:

When this error is detected, the equipment might experience slightly altered throttle response, but the impact on overall performance is minimal. The system continues to operate but may log the fault for monitoring purposes.

Recommendations:

Inspect Hand Throttle (P03) Without ECU:

• Check the hand throttle for proper operation.
• Ensure the throttle is not damaged and is correctly positioned.

Verify Wiring and Connections:

• Inspect the wiring harness connected to the throttle sensor for any signs of damage, wear, or loose connections.
• Repair or replace any damaged wiring.

Test Power Train Hydrostatic Control Unit (PTH):

• Perform diagnostic tests on the control unit to identify any faults.
• Verify all electrical connections to the control unit are secure and corrosion-free.

Update Control Software:

• Ensure the control unit software is current with the latest updates and calibrations.

Consult Technical Support:

• If the fault persists, contact technical support for further diagnostics and possible sensor replacement.

Monitor System Performance:

• After addressing the issue, monitor the throttle system to ensure normal operation and that the fault does not reappear.

Note:

Regular inspection and maintenance of the throttle sensor and associated wiring can prevent this fault. Environmental factors such as extreme temperatures or exposure to moisture can also impact sensor performance, so these factors should be considered during troubleshooting.